When you notice that the rubber has worn enough so that it doesn't hold the blade from moving from side to side, you should replace them. Clean out any sediment that has accumulated, rinse the inside with fresh water, and inspect the rubber wheel inserts for wear. You should open the covers and inspect the working parts on a regular basis. What sort of preventive maintenance should I be doing? Watch this video for a short demonstration of using the Separating Blade.Ħ. Watch this video for a quick course in changing the blade.Ī Separating Blade allows you to make inside cuts without a lead-in. Emptying the base of the new water is a good idea if the saw will be sitting for a while, as the lowest pulley inside the saw would otherwise be sitting in water. This will help to rinse out the glass dust that was in the dirty water and has accumulated on the inner workings. We recommend that after using the saw you empty the base, add some clean water, and run it for a few seconds. Should I be taking any precautions when I don't plan to use the saw for awhile? In a pinch, you can use Chap Stick or Vaseline.Ĥ. Your stained glass dealer can probably recommend some commercial products that can be applied over a regular felt marker lines to improve their resistance to water. You can also copy your pattern onto overhead transparency material and glue or tape the pattern to the glass. We have found these at our local Staples, and Office Depot has something similar. The most popular of these seems to be the Pilot Extra Fine Gold and Silver Creative Marker. There are markers available that use paint rather than ink, and these are well suited for marking patterns on glass. For this reason regular markers, such as Sharpies, quickly wash away. What is the best way to mark the pattern before I cut?Īs you undoubtedly have or will discover, the glass gets wet when you use a diamond saw. Next, take your right thumb and push the right side of the platform towards the center of the saw and down. Fit the left rear corner into the slot running around the base.
#Gryphon studio grinder manual install#
To install the work surface, put it in place starting with the left rear corner. The surface is easy to install once you know the technique. The work surface is designed to fit tightly so that it will not rattle. I'm having trouble putting the work surface on. The Zephyr has a larger throat than the other saws in its class, which can be useful for some jobs.įollow this link for an overview that describes the differences between the various types of diamond saws.Ģ. The main section of the saw can be removed from the base to allow the saw to be used hand-held. Many people prefer the ability to cut in any direction, as they find it intuitive and useful. The Zephyr Ring Saw is smooth and quiet and cuts in any direction. How do I choose the saw that is right for me?
LiftOff reservoir that makes cleanup fast and easy.Huge, 14 ½" (36.8cm) x 11 ½" (29.2cm) work surface is 16% larger than closest competitor.Close-up image shows the covered accessory tray to store your supplies. Hobbyists looking for "the best" will also enjoy this workhorse machine.
#Gryphon studio grinder manual professional#
The Inland Wizard IV™ Stained Glass Grinder was designed for the professional glass artist.
0 kommentar(er)
